Introduction

The SellVOIP Configuration Module can configure Trixbox to use SellVOIP with a minimal amount of effort.

Getting Started

Once you've signed up for SellVOIP, you'll get a welcome e-mail with your Portal username and password. If you're planning on getting phone numbers (also called DIDs), log into the Portal and add them first. Keep your portal username and password handy, because the SellVOIP Configuration module will need it to retrieve your account settings.

You'll also need Trixbox version 1.2.2 or later from trixbox.org.

Enabling the Configuration Module

In your web browser, enter the URL of your Trixbox machine and click "System Administration". The default username is "maint" and the default password is "password".

Next, click on "Service Provider Wizard" and then "SellVOIP". Enable the module by clicking "Continue"....





... and then launch the module by clicking "Launch the SellVOIP module".

Using the Configuration Module

The SellVOIP module will need your Portal username and password in order to retrive your account settings. Enter this information and click "Log In"....



If the username and password you supplied were correct, you should see a list of access accounts tied to your SellVOIP account. Chances are, you only have one account. Choose the account you'd like to configure and click "Configure".



The configuration process is complete when you see the image below. Make sure to click the red bar to apply the changes made by the module.



At this point, you should be able to make outbound calls through SellVOIP. If your account had one or more phone numbers (DIDs) assigned, an extension was created for each DID.

Copyright

This document is © 2006 Blue Networks, Inc. All Rights Reserved.